Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi Rahul
Can you explain what you're going to do and can you please give me a bit more information so i can help you according to what you exactly need ?
Are you sure you'd really prefer an arc heat source,
over an induction melt? Getting an arc heater to
survive for long at all requires things like a whole lot
of inert gas, a lot of attention to cooling the electrode
(presumably you are not going to want to replace
expensive designed & machined high power tungsten
electrodes every minute or so) and so on. Induction
systems don't really have the same consumables
problem.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
