Hello,
i have designed an EBG cell given in the link .......https://www.emtalk.com/tut_3.htm i am getting the below warning. can you tell me how can we overcome this.
PML group 'PMLGroup2' part 'PML_Box1' is contained by object 'Box3'
OK, so it looks like the tutorial uses another air box for the express purpose of supporting boundary conditions -- thats fine. As per the tutorial, "Therefore, another airbox has to be created with encloses the original airbox and PML". Make sure that this box does not intersect with the PML; it should completely enclose it.
It is always better not to get any warnings but you can go ahead and check filed and other parameters and compare them with some reference. You can also resolve this issue by assigning priority to the boundary in the overlapping region
You could ignore the warning if that's the case, but you can also do an alternate technique (which is what I do):
Instead of the outer box, simply place sheets along the original vacuum box, and make sure they extend over the entire face of the domain (including the PML). Apply the M/S boundaries to these sheets. No need for sheets on the top and bottom.
Hi, planarmetamaterials.... the alternative technique you suggested was working.....Final doubt....To plot the Dispersion diagram i need to find the frequency isn't it? ....i am thinking like this.....Beta=2*Pi/Lambda.....Lambda=C/f..... what value should i put in the Beta variable?
- - - Updated - - -
Meanwhile i have designed a EBG based slot antenna paper from IEEE.... i have designed the Unit cell and i got the frequency phase shift diagrams similar to the ones on the paper....but i desinged the whole antenna Hfss stops the simulation process abruptly....can you please suggest me what should i do.View attachment array1.rar
Master/Slave boundaries take a phase shift, where the phase along an axis is given by Beta*d, with d being the period of the unit cell. The first Brillouin zone is bounded by Angle = [0,180] degrees.