Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Easy-PC & Drill symbols/table - demo and full version?

Status
Not open for further replies.
M

mkbs

Member level 3
Member level 3
Joined
Apr 10, 2003
Messages
67
Helped
4
Reputation
8
Reaction score
2
Trophy points
1,288
Activity points
626
Easy-PC & Drill

Hi to all,
I have seen,for my little pcb (max 800 pins), Easy-PC from Number One System. From the Demo version I haven't seen if it create a drill symbols/table to gerber file. Does someone use it?

mbks.
:?: :) :?:
 

Search to Elektroda of non demo version or patch :wink:
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top