wan65
Newbie level 6
Hello
I want to use this service:
https://support.seeedstudio.com/knowledgebase/articles/388503-what-are-the-pcb-panelization-rules
but I don't fully understand what do they mean with their requirements...
So far I've done this:
I have the same board 3 times, but what do they mean by "V-cuts on 20 layer"? The 20 layer is board outline:
![](https://obrazki.elektroda.pl/7063835200_1489785573_thumb.jpg)
Is this okay?
Also, which JOB script for eagle should I use to export the gerbers for seeedstudio?
I want to use this service:
https://support.seeedstudio.com/knowledgebase/articles/388503-what-are-the-pcb-panelization-rules
but I don't fully understand what do they mean with their requirements...
So far I've done this:
![](https://obrazki.elektroda.pl/5151816400_1489785501_thumb.jpg)
![](https://obrazki.elektroda.pl/6381426800_1489785501_thumb.jpg)
![](https://obrazki.elektroda.pl/5144103200_1489785502_thumb.jpg)
I have the same board 3 times, but what do they mean by "V-cuts on 20 layer"? The 20 layer is board outline:
![](https://obrazki.elektroda.pl/7063835200_1489785573_thumb.jpg)
Is this okay?
Also, which JOB script for eagle should I use to export the gerbers for seeedstudio?