Eagle Pro...Gerbers incluse copper pours when pours have been "unpoured"

Status
Not open for further replies.
T

treez

Guest
Hello,

I have a PCB with multiple copper pours on it. I can "ripup" these pours , so that i can inspect the PCB more easily. (when ripped up, the pours are still there, but only theIR outline is there)

Supposing i forget to fill the pours back in again when making the gerber files......does this mean that the pours would not appear in the gerber files?....and thus the PCB manufacturer would not make the pours on the PCB?
 

Re: Eagle Pro...Gerbers incluse copper pours when pours have been "unpoured"

The copper pours are automatically done by the CAM processor - you do not have to do it, it is purely a visual aid for you. You can easily check by loading a board with copper pour and running the CAM processor and checking the Gerbers.

Keith
 
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.
Cookies are required to use this site. You must accept them to continue using the site. Learn more…