Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
in the device MC1541TT (IC5) the GND pin direction is set to "output". Please set it to "passive":
open library "microchip.lbr"
look for device "MC15*". open it
check what symbol is used for it ("INFO" and mouse click on the symbol)
open this symbolwithin the library editor
press "change direction passive" and [enter]
mouse click on the "VSS" pin
save library
go back to schematic
update library "microchip"
save
run ERC.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.