eagle pcb has giving DRC or ERC problem

[Rajesh_ece]

hi ,
here i had attached the schematic of eagle , it was giving error's when checking in ERC.
supply and output pins were mixed like that,

can u any one solve this problem in this schematic

thank you
regards
Rajesh

 

[KlausST]

Hi,

in the device MC1541TT (IC5) the GND pin direction is set to "output". Please set it to "passive":

open library "microchip.lbr"
look for device "MC15*". open it
check what symbol is used for it ("INFO" and mouse click on the symbol)
open this symbolwithin the library editor
press "change direction passive" and [enter]
mouse click on the "VSS" pin
save library

go back to schematic
update library "microchip"
save
run ERC.

the errors should be gone.

Klaus