eagle pcb has giving DRC or ERC problem

Status
Not open for further replies.
R

Rajesh_ece

Newbie level 4
Joined
May 15, 2014
Messages
5
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
46
hi ,
here i had attached the schematic of eagle , it was giving error's when checking in ERC.
supply and output pins were mixed like that,

can u any one solve this problem in this schematic

thank you
regards
Rajesh
 

Attachments

  • test.rar
    60 KB · Views: 48

Hi,

in the device MC1541TT (IC5) the GND pin direction is set to "output". Please set it to "passive":

open library "microchip.lbr"
look for device "MC15*". open it
check what symbol is used for it ("INFO" and mouse click on the symbol)
open this symbolwithin the library editor
press "change direction passive" and [enter]
mouse click on the "VSS" pin
save library

go back to schematic
update library "microchip"
save
run ERC.

the errors should be gone.

Klaus
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…