Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

dsPIC programming help

Status
Not open for further replies.
A

arul_0317

Newbie level 3
Newbie level 3
Joined
Jul 19, 2012
Messages
4
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Visit site
Activity points
1,323
Hi everyone,


I'm working with dsPICDEM MCLV board and i'm using MPLAB ICD3 in-circuit debugger as a communication device,
i'm also using mplab ide v8.87 as the software,

and my project is to basically control the Pulsewidth of the square wave that i get when i connect a CRO from M1 to ground, with the POT.

I've attached the codes and can anyone tell me how to do this, thanks.

I can't understand the code as well.

Thanks,
Arul.View attachment Interrupts.txtView attachment Init.txtView attachment SensoredBLDC.txt
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top