dsPIC build error code

[P.Copper]

Hi all

I'm running a dsPIC30f4013 with MPLAB X IDEv1.60. when i try to build my code it gives me this error code

"Target Device ID (0x0) does not match expected Device ID (0x1410000)"

If anyone has encounted a similar problem help will surely be appreciated. thanks

 

[mithun mohan]

are you using a development board ?.... if so what is that ?

 

[P.Copper]

are you using a development board ?.... if so what is that ?

I'm not using any development board, i'm using a PICKit3 programmer... to program the dsPic30F chip

 

[ChansAlive]

Hi P.Copper,
I too experienced the same problem while using pickit 3. I sometimes turn-off the devices(including PICkit) and then restart it. But later I came to know that, it was due to the fault in the design which caused wrong voltage levels in the PGD and PGC. This was due to a faulty CAN TxRx IC connected to the same PGD and PGC pin used for flashing. So it caused error in the initialization of connection between the PICkit 3 and the controller. After it was corrected, there was no further error happened while flashing.
So I think you better check the connection with the controller and PICkit 3 and compare with the requirements...