Considering the driving device, and probable switching speed (lowish I presume) either a dasiy chain or parallel connection would probably work, it has enough current drive.
In situations like this I would get the engineers opinion, then probably use my SI tool to check different options (I have the tool, so mite as well use it.) if I had any doubts.
Depending on layout topology would determine my choice. If the two MAX4167s are near each other I would probablu use daisy chain, if they are seperated I would use parallel.
---------- Post added at 10:45 ---------- Previous post was at 10:42 ----------
Considering the driving device, and probable switching speed (lowish I presume) either a dasiy chain or parallel connection would probably work, it has enough current drive.
In situations like this I would get the engineers opinion, then probably use my SI tool to check different options (I have the tool, so mite as well use it.) if I had any doubts.
Depending on layout topology would determine my choice. If the two MAX4167s are near each other I would probablu use daisy chain, if they are seperated I would use parallel.
More info on the schematic and general layout would help, as without the intimate knowledge I can only give vauge suggestions.