Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Drawdio schematic help, please

Status
Not open for further replies.
Pin "R" is reset . Small circle in symbol means inverted input
i.e. Reset is active as low "0".

Speaker + and - are usually used for marking direction of cone movement,
( used eg. in speaker boxes ; where phasing of speakers is important,
for linear frequency response etc. )
Here , in this circuit don`t care about those marks.
 
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top