Non AMP

Doubts over Orcad 16 simulation using PIC and LCD display

Thread starter eletmoraes
Start date Jul 19, 2012

Status: Not open for further replies.

Jul 19, 2012

#1

E

eletmoraes

Member level 2

Can simulate in Orcad 16 lcd using pic and display the letters that appear in the display the same way as in Proteus?

Jul 27, 2012

#2

willis...

Full Member level 2

Not sure about that. I know that you should be able to simulate it in Multisim though.

Status: Not open for further replies.

Similar threads

N
How to put differential signal symbol in Orcad capture 17.4
- Started by newbie_hs
- Feb 13, 2024
- Replies: 2
PCB Routing Schematic Layout software and Simulation programs
E
Batch simulation in Hyperlynx
- Started by engr_joni_ee
- Aug 2, 2023
- Replies: 0
PCB Routing Schematic Layout software and Simulation programs
E
DC Drop simulation in Hyperlynx PI
- Started by engr_joni_ee
- Jul 31, 2023
- Replies: 0
PCB Routing Schematic Layout software and Simulation programs
C
[HSPICE] .ac simulation: The input is scaled down a thousand times
- Started by ch hsiao
- Sep 11, 2023
- Replies: 3
PCB Routing Schematic Layout software and Simulation programs
E
Two voltage sources and a power plane
- Started by engr_joni_ee
- Feb 26, 2024
- Replies: 1
PCB Routing Schematic Layout software and Simulation programs