"Done pin didn't get high" error when programming Spartan 2 in slave serial mode
hello
Do somebody help me ?
My problem is about programing Xilinx Spartan 2 (xc2s150 )
I program it by ISE 6.3 software
when it's programming in mode slave serial,give a error massage. Done pin didn't get high.
even the pin is connected VCC with resistor 3.3K but there is a error massage.
THE error is Done pin didn't get high.
That's probably the single most common Xilinx FPGA problem. A huge number of things can go wrong depending on your hardware setup. Go to Xilinx web site and search for "DONE Pin does not go HIGH" or maybe "troubleshooting DONE", and try to narrow down the search using other keywords specific to your hardware setup.