Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Doesn't work with mm only mills in Capture CIS

Status
Not open for further replies.
S

StoppTidigare

Full Member level 2
Joined
Jul 16, 2002
Messages
148
Helped
1
Reputation
2
Reaction score
0
Trophy points
1,296
Location
Northern earth
Activity points
1,703
Hi all, I've finally started to learn a layout tool:Cadence Orcad Layout plus. Before this Layout-program I use Caputure CIS, There under Tools->Create Netlist->Layout one must use "Use properties are in inches", else Layout plus complains and says sometjing about "template bla bla"
Is there a way to go round this ?
The suppliers catalog specifies footprints in mm, so I have to recalculate ...boring!

regards,
StoppTidigare
 

Goto: Options: System Settings or Ctlr+G it's there.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top