Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
i use the MICRF011 but it doesn,t work
the MICRF011 is in the sweep mode
i use a tunable cheap LC transmitter
i use a led and a resistance
on the data output to see the output
later on i discover that the max current out of this pin is 10uA
it didn,t work because i take too much current out of the pin or what ?
i test the LC transmitter on a regenerative receiver woking on 300Mhz and it works
the MICRF011 works with 5.5M ceramic resonator
cth = 47n
c AGC= 2.2u
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.