Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

direct conversion receiver iip2 and balun mismatch

Status
Not open for further replies.

mesfet

Full Member level 2
Joined
Jan 4, 2002
Messages
131
Helped
3
Reputation
6
Reaction score
3
Trophy points
1,298
Activity points
1,111
Hi all,

I saw many ieee papers describing how to improve IIP2 of direct conversion receiver by circuit design and calibration techniques. Since most of the on-chip LNA are differential, a balun is needed. Anyone has any materials on how amplitude and phase mismatches from balun affect reciver IIP2 peformance?


Thanks,
Mesfet
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top