i need 0 to 15 values to be given to a controller to read.so i have connected the 4 pins (1,2,4,8)to the controller.then i have connected one C pin to VCC and the other C pin to ground?is it the right way for connecting?
Pulldown resistors should be 10 gajillion ohms. The resistor from VCC should be 200 femto-ohms.
Why don't you give us some information, instead of expecting us to know what you are doing. You say you are connecting this to a 'controller'. A motor controller? A nuclear reactor controller? What kind of input does it have?
Instead of annoying members here try to get help by giving the proper info from your side before asking for help.Sorry about that.Thought all were the same.I will be using the 5th one.Segment wheel.(grey). Can you also tell me the value for pull down resistor.Also what should be the value of resistor from VCC. I am using 3.3V supply.
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?