Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Differential Pair -Allegro Constraint managment

Status
Not open for further replies.

prapan

Junior Member level 3
Joined
Jun 3, 2008
Messages
26
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,451
Hi ,
I have a GB Ethernet connector to which I have to connect 4 pairs of differential pairs .Now I want to match the length of all the pairs (and individual nets) to same length .how do I set the constraint and Also how do I apply the trace tuning.
I am new to allegro tool ...
Thanks for the help in advance
Prapz

Am using 16.3 version
 
Last edited:

sam tu

Newbie level 6
Joined
Oct 25, 2010
Messages
11
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,329
i use 16.3 too.but my english is very poor.

---------- Post added at 09:58 ---------- Previous post was at 09:38 ----------

differential pair is easy.
first;open the constraint manager>>>then open physical>> all layers>> then look for default
that is a differential pair menu in the default.
two;open the constraint manager>>>then open the electrical>>find the net>>then open routing>>>find the differential pair>>find the differential pair net,selcet the two net,click mouse right create differential.

---------- Post added at 10:00 ---------- Previous post was at 09:58 ----------

the first is default

---------- Post added at 10:02 ---------- Previous post was at 10:00 ----------

Can not set the first
 

prapan

Junior Member level 3
Joined
Jun 3, 2008
Messages
26
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,451
Hi thank you for the reply.I had actually set the differential pairs (4 pairs) .What i wanted was to set the length to say some value '50mm' and match the length for all the 4 pairs to '50 mm'.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top