Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] Designing a 3 dB attenuator in ADS

Status
Not open for further replies.
J

jadnounyah

Junior Member level 3
Joined
Aug 21, 2022
Messages
30
Helped
0
Reputation
0
Reaction score
0
Trophy points
6
Activity points
297
I'm working on designing a 3 dB attenuator for an inter stage of a two stage power amplifier. I've done a setup for optimizing the values of transmission lines to a achieve such an effect but the results weren't satisfactory since I wasn't getting the half power out put at the end. Please any help? Thank you.
1689086431090.png
 

Attachments

  • 1689085755499.png
    1689085755499.png
    13.5 KB · Views: 67
  • Screenshot 2023-07-11 143114.png
    Screenshot 2023-07-11 143114.png
    59.8 KB · Views: 70
  • 1689085979925.png
    1689085979925.png
    60 KB · Views: 74
  • Screenshot 2023-07-11 143114.png
    Screenshot 2023-07-11 143114.png
    59.8 KB · Views: 61

Sort by date Sort by votes
Yhyh seen my mistake, they're lossless. Infact there is an attenuator in the ads for such a purpose so I just used that one instead. Thanks for the submission.
 

Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top