Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Defining port 'inside' substrate in HFSS

Status
Not open for further replies.
S

soaringeagle

Junior Member level 3
Junior Member level 3
Joined
May 25, 2013
Messages
30
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Visit site
Activity points
1,514
How can I define lumped port inside the substrate ? We always work with the ports that lie at the edges of the substrate. But I need to define a lumped port that lies at some point inside the substrate, how can I do that? I will appreciate quick response.
 

Hi.
at first i should know ,what is your design exactly,and then help you.
Good Luck
 

problem.png

You can see the attached figure. I have explained the problem in detail.You can see that port has been defined somewhere in between the substrate.To do this , do I have to create a hole in the substrate to make space for the 'port ' ?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top