Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Debugging using Keil for Actel SmartFusion Development Board

Status
Not open for further replies.
D

devank.purohit

Newbie level 6
Newbie level 6
Joined
Dec 5, 2012
Messages
14
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Visit site
Activity points
1,373
I am trying to debug a tutorial program provided by Actel on its SmartFusion Development Kit using Keil MDK ARM 4.70a. As per the tutorial, I have ensured all the jumper settings are in order. Initially, when I tried to debug the program, I got a message displaying "Need to update the firmware", to which I clicked "Ok". After a while though, I got error message stating that "Firmware update failed". After this message, whenever I try to debug, I get an error message stating "No JTAG Devices found". I have checked the jumper settings again and again, but to no avail. I am using a Ulink2 Debugger. Please help me out. Thanks!
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top