Hi every one,i want some help in boost dc to dc converter,in calculations and in simulation results are fine.My problem is implementing into practical, my converter was design to work 3KW Power,which means 60V *25A,during some period the capacitor current became 25A, and i couldn't fined any capacitor which can handling this amount of current,thanks in advance.
med
At these Ampere levels you might want to consider interleaving 2 or more boost converters. It will greatly reduce stress on your smoothing capacitor as well as other components.
Simulation:
I went with your figure of 60V and 25A.
It totals 1500W rather than 3kW.
Notice the smoothing cap has less than 10A going back and forth through it.
If that is too much, then you'll need to put a gang of capacitors in parallel.