SO my question is:
Any idea on where to begin troubleshooting this? All of my code changes to run the ADC/DAC, down to cutting out all but the necessary components function fine on my DEO board, but refuses to work on the PCB. I'm able to toggle pins on the PCB with new code, and am able to output clocks. Currently I'm starting from the bottom up, adding things back in until something breaks. Are there any incompatibilities with code that I should worry about? common .sof to .pof conversion issues or settings that might have been accidentally changed?
I know that I'm grabbing at straws at this point, but any help or ideas would be greatly appreciated. I can post code or anything else that you might need, Thanks!