Bjtpower
Full Member level 5
Dear Friends
i am planning to develop a isolated current Sensing Methods for AC Current sensing.
I have one CT1248 (1:1500) and recommended Burden is 84ohm
Now if i want to amplify the same signal and give it to the Controller Pin.
What will be the Probable circuit..??
I have used earlier AD620 for amplification but its not the good selections as it is Differential Amplifier and full voltage swings to 2.2V when we apply 3.3V supply at its terminals
i want to have full access of 3.3V which we can give it to the Controller.
Regards
Marx
i am planning to develop a isolated current Sensing Methods for AC Current sensing.
I have one CT1248 (1:1500) and recommended Burden is 84ohm
Now if i want to amplify the same signal and give it to the Controller Pin.
What will be the Probable circuit..??
I have used earlier AD620 for amplification but its not the good selections as it is Differential Amplifier and full voltage swings to 2.2V when we apply 3.3V supply at its terminals
i want to have full access of 3.3V which we can give it to the Controller.
Regards
Marx