What I wanted is to do a simulation on just the antenna section and then add separate lumped element matching network so that I can match with the impedance of the nRF chip ANT port. Is it ok to add the entire ground plane and then add matching network separately?
I have attached an image of the actual top layer and bottom(Blue - Ground) layer PCB design.
As you can see, the blue color ground plane is not completely a plane. In this case should I draw a one big ground plane with the same size as the circuit?
I am also bit not clear on applying discrete port positive and negative port pin definitions.
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?