Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

CST-MWS Tuning not showing automatically on s-parameter

Status
Not open for further replies.
T

teemaciba

Newbie level 4
Joined
Feb 20, 2016
Messages
6
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
43
This happened out of no where! I created a new file and added capacitors in the schematic view. Then I started tuning to look at the changes in the s parameter like I did in all my other designs. However, this time every time I move the capacitor value the setup solver starts simulating again and it takes waaay too long.
pleaase help
thank you
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top