Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

CSR Headset Current Consumption ?

Status
Not open for further replies.

wessoms

Junior Member level 1
Joined
Jan 15, 2002
Messages
16
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Activity points
74
Does any one out their know roughly what the current consumption is for the CSR module being used a headset in SLEEP , IDDLE , and connection ? Does the CSR module also support Sniff during connection ? so it will work reliably with the Nokia phones.
 

Phil woz ere

Full Member level 2
Joined
Feb 12, 2002
Messages
130
Helped
6
Reputation
12
Reaction score
3
Trophy points
1,298
Location
UK
Activity points
968
Current consumption for bluecore2 external

Sleep mode 18uA.
Idle it depends on what state the chip is in.
Current consumption will vary depending on if it goes into deep sleep
or if it is sniffing. If you use a long interval the chip will sleep thus reducing
the current consumption. A short interval and the chip will not sleep and the current is a little higher.
There is current consumption information in their data sheet based on a 1.2 second sniff rate and also for Park and Deeep sleep.
Yes the CSR chip supports sniff during connection and does work with Nokia phones.

Hope this helps Phil :D
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top