Please read through them and then pleas ask specific questions what you don´t understand or where you need help.
First read about the hardware interface (SPI) to build aconnection to your microcontroller.
Then soon you will need the calibration of the ADC.
After tat you need to know what you want to do / how you want to process the data. We don´t know - you have to tell us.
Datasheet says it hat SPI interface, that´s the way for your AT89S52. And datasheet says it is possible to use an auto configuration EEPROM.
What have you done so far? Schematic, ideas, code....
Again, please read datasheet carefully and ask a question related to a special paragraph in datasheet you don´t understand.
Also you may find good additional information on the cirrus internet site.
i have connected 0-100 kg load cell with cs5460 interface with 89s52 as well done my code for get display on seven segment
but problem is there is variation on seven segment display , so any one tell me
which section i should have to read of datasheet to get accurate reading ... any reference circuit