Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Coupling factor of common mode choke?

Status
Not open for further replies.
T

treez

Guest
Newbie level 1
Hello,
Do you know what is the coupling coefficient of this common mode choke?

SRF0504-191Y
https://www.bourns.com/data/global/pdfs/SRF0504.pdf

(We will use it on a 24vin, 19vout, 2a5=iout LED driver board.)
We need to evaluate ringing overvoltage between the leakage of the CMC and the input caps of the driver card, so we need to know leakage
 

It's essentially simple. You can
- ask the manufacturer for additional data
- measure the missing parameters yourself
 
  • Like
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
thankyou, I was also going to ask why these common mode chokes all have such low mutual inductance....but then I suppose this is because the frequencies dealt with by CMC's are very very high?
 

Hello,
Do you know what is the coupling coefficient of this common mode choke?

SRF0504-191Y
https://www.bourns.com/data/global/pdfs/SRF0504.pdf

(We will use it on a 24vin, 19vout, 2a5=iout LED driver board.)
We need to evaluate ringing overvoltage between the leakage of the CMC and the input caps of the driver card, so we need to know leakage

DCR is 20mΩ per line so if Vin is 24V the drop is only 50mV per line. 19Vout I assume is after PWM. Since this is common mode it suppresses radiated noise not differential conducted noise.

The effectiveness is based on ratio of impedance thru 0.6µH and impedance to ground plane. Thus if DC is floating, differential caps to ground provide additional suppression.

The differential inductance will be very small compared to each leg.
 
  • Like
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
thankyou, I was also going to ask why these common mode chokes all have such low mutual inductance
There are essentially two types of common mode chokes, signal chokes with intentionally low leakage inductance respectively high coupling factor to get high signal bandwith along with the common mode filtering and power chokes with intentionally high leakage, to implement an additional filtering of differential noise.

I agree that it would be better to have complete specifications in the datasheets, but that's apparently asking too much.
 
  • Like
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top