Corner PADs are not fitted in SoC Encounter.

[kopern1k]

Hi, guys.

I have the following problem. My netlsit have a group of pads that have also 4 corner pads. When I load the design in Encounter it includes corner pads together with other pads. And I'm not able to drag them in corner places because when I let my mouse go this pad slips out to the closest side place.

So what I should do with my code to fix this.


Thanks in advance.

 

[Manochitra]

Hi, guys.

I have the following problem. My netlsit have a group of pads that have also 4 corner pads. When I load the design in Encounter it includes corner pads together with other pads. And I'm not able to drag them in corner places because when I let my mouse go this pad slips out to the closest side place.

So what I should do with my code to fix this.


Thanks in advance.

hi..
check in ur io file that u have mention this sides
Pad: c0 SW
Pad: c1 NW
Pad: c2 NE
Pad: c3 SE

 

[vijayR15]

Hai kop,
Ya mano is right.

If u still couldnt get then add the below command in lef file for the macro pad

CLASS ENDCAP BOTTOMLEFT ;

:razz: