Controlling the TB62706BN LED driver with PIC

[ultrabrains]

Hi,

Has any one worked with this TB62706BN LED driver. I read through the datasheet and followed the Timing Diagram but it gives no Output.
Only the Serial out pin gives an output corresponding to the Serial input.

Thanks.

 

[Arch Zone]

- If you can get serial output, maybe, there's something wrong at Latch or Enable (See at Block diagram on Datasheet)
- Output will be exist if Enable is low and falling-edge of Latch.
- please check again, Latch pulse Width must be > 100 ns and Enable.
- And maybe you have to change RL value on LED.

Thank you.

 

[ultrabrains]

Thanks a lot,

I will check the enable and Latch carefully.