Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
sorry don't have a book studying through internet so if you could point to some source i'l be grateful.
i'll try to be more specific. so there are two modules, data from output of one module is to be sent to the input of other module.
i have couple of things in my mind about what to do.
firstly i thought that i'll call module.
eg: module a (x,y,z)
b M1 (c,x,d); //module
so should i use the same variable name as 'x' in eg. or can i do that i use different variable like 'w' and then put x=w.
i was also thinking of calling both modules in a third module and put x=w there.
other thing i was thinking of was calling both modules in a TB and assigning it but i guess this will only work in simulation and not sythesis.
so someone could explain with a small eg. how to proceed.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.