Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
If u have a process document just refer that, there u have these values.
The notmal Metal width used inside the std cells shud not be used here and the width of the metal lines that are used to connect to PAD and Power rings are usually higher.
I am sure that these values are present in the Process Document.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
