ssheikmd
Member level 1
Hi,
I have lot of confusions in applying parameters for the simulation of Low pass filter.
The details of parameters are as follows:
fc=1GHz, Passband ripple= 0.1dB, Zo=50, dielectric constant =10.8, lenght of c = 7.11, lenght of l=9.81, width of c=4 and width of L=0.2.
Whether the values i applied in synthesis is correct. (attachment)..
Which values i should i apply in High and Low Impedance Line?
Then..How should i select the parameters for straight strip.
Please help me..
Thanks and Regards,
Sheik Md.S[/img]
I have lot of confusions in applying parameters for the simulation of Low pass filter.
The details of parameters are as follows:
fc=1GHz, Passband ripple= 0.1dB, Zo=50, dielectric constant =10.8, lenght of c = 7.11, lenght of l=9.81, width of c=4 and width of L=0.2.
Whether the values i applied in synthesis is correct. (attachment)..
Which values i should i apply in High and Low Impedance Line?
Then..How should i select the parameters for straight strip.
Please help me..
Thanks and Regards,
Sheik Md.S[/img]