samy555
Full Member level 4
Hi
I've built this oscillator, then I implement it using a simulation program LTC, which is used by most of you, but unfortunately it did not work permanently.
Here is the Circuit Diagram
Here is the simulation software file easier for you to check the circuit
www.edaboard.com/attachment.php?attachmentid=108250&stc=1&d=1407863886
Notes
Each coil has its internal series resistor
The 50 ohm load is an antenna which is matched to the output of the OSC. Through the tap.
I need your help
Any inquiry about the values of the elements I am ready to answer
Thank you
I've built this oscillator, then I implement it using a simulation program LTC, which is used by most of you, but unfortunately it did not work permanently.
Here is the Circuit Diagram
Here is the simulation software file easier for you to check the circuit
www.edaboard.com/attachment.php?attachmentid=108250&stc=1&d=1407863886
Notes
Each coil has its internal series resistor
The 50 ohm load is an antenna which is matched to the output of the OSC. Through the tap.
I need your help
Any inquiry about the values of the elements I am ready to answer
Thank you