BillQ
Junior Member level 1
For the circuits which are only operating under DC condition(there is no AC small signal)
Should I characterize the CMRR, PSRR, noise of the circuits?
(Anyway, I think offset should be measured, slew rate also.
But I think noise only refers to the AC operation, normally CMRR; PSRR are also simulated by XF sweeping the frequency.
Just a litte confused)
:|
Should I characterize the CMRR, PSRR, noise of the circuits?
(Anyway, I think offset should be measured, slew rate also.
But I think noise only refers to the AC operation, normally CMRR; PSRR are also simulated by XF sweeping the frequency.
Just a litte confused)
:|