Martynas Jankūnas
Newbie level 6
Hello,
I uploaded thermistor firmware to XRF module and now it's responds just to "+++" command over serial monitor, also heartbeat led is always on. From my researches I think XRF is in bootloader mode, but I'm still not sure. I tried several firmware versions with two diferent modules, all is the same.
To upload firmware I used XRF config manager (XCM) and a board with FTDI232 chip, upload process finished without errors and I'm able to check new firmware version.
**broken link removed**
Any help is appreciated
I uploaded thermistor firmware to XRF module and now it's responds just to "+++" command over serial monitor, also heartbeat led is always on. From my researches I think XRF is in bootloader mode, but I'm still not sure. I tried several firmware versions with two diferent modules, all is the same.
To upload firmware I used XRF config manager (XCM) and a board with FTDI232 chip, upload process finished without errors and I'm able to check new firmware version.
**broken link removed**
Any help is appreciated