Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[General] Ciseco XRF module new firmware upload

Status
Not open for further replies.
M

Martynas Jankūnas

Newbie level 6
Joined
Aug 9, 2015
Messages
13
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
152
Hello,
I uploaded thermistor firmware to XRF module and now it's responds just to "+++" command over serial monitor, also heartbeat led is always on. From my researches I think XRF is in bootloader mode, but I'm still not sure. I tried several firmware versions with two diferent modules, all is the same.
To upload firmware I used XRF config manager (XCM) and a board with FTDI232 chip, upload process finished without errors and I'm able to check new firmware version.
**broken link removed**
Any help is appreciated :)
XCM.pngSerial_monitor.png
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top