We might be doing a 180 nm start here, currently we've only done FPGA work. I think we're looking at somewhere between 500K and 1M gates for the design, digital only.
Any suggestions on a reasonably priced place and route tool? So far Magma's cost a lot, and the Synopsys sales droid gave a figure of "in the upper 6 digits and up" for the cost.
You can try the Tanner Tools.. Though they are analog tools..there's a SPR module that does digital place and route! I heard tanner isn't that expensive too..
How much do you have? Why don't you deal with the design service to tap-out that chip for you.
I think that is cheap for temporate license (Magma or Synopsys). So if you want to buy the license, I suggess the Magma-da. They have also Magma-EA engineers to help you run the tool quickly.