Mike_D
Newbie level 4

We might be doing a 180 nm start here, currently we've only done FPGA work. I think we're looking at somewhere between 500K and 1M gates for the design, digital only.
Any suggestions on a reasonably priced place and route tool? So far Magma's cost a lot, and the Synopsys sales droid gave a figure of "in the upper 6 digits and up" for the cost.
Thanks,
Mike
Any suggestions on a reasonably priced place and route tool? So far Magma's cost a lot, and the Synopsys sales droid gave a figure of "in the upper 6 digits and up" for the cost.
Thanks,
Mike