kathykmk
Newbie level 1
CC2500 and MCU PIC18F452
Greetings All,
Recently i have bought a pair of RF transceivers module with CC2500,
i have gone through the datasheets of cc2500 and they highly recommended to use SmartRF studio in configuring the registers of cc2500, the problem that i facing now is, i only have the RF transceiver module, but do not have the ti's developement board.
if i configure the registers using smart Rf studio, how i going to send this configurations into the RF transceiver module?
SmartRF® Studio communicates with the evaluation boards through the USB port (SmartRF®03/04/05) or the parallel port (SmartRF®01/02).
i do not have the evaluation board.
and also how to know which registers are to be configured?
Thanks to all experts that kindly reply me...
Greetings All,
Recently i have bought a pair of RF transceivers module with CC2500,
i have gone through the datasheets of cc2500 and they highly recommended to use SmartRF studio in configuring the registers of cc2500, the problem that i facing now is, i only have the RF transceiver module, but do not have the ti's developement board.
if i configure the registers using smart Rf studio, how i going to send this configurations into the RF transceiver module?
SmartRF® Studio communicates with the evaluation boards through the USB port (SmartRF®03/04/05) or the parallel port (SmartRF®01/02).
i do not have the evaluation board.
and also how to know which registers are to be configured?
Thanks to all experts that kindly reply me...