Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Can't read tr0 file from Hspice into Matlab

Status
Not open for further replies.
D

diligentmarch05

Newbie level 2
Joined
Jun 21, 2010
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,291
Hi, I am trying to test my ADC. When I type loadsig('adc.tr0'), it says "Not enough input arguments", and then I check loadsig and find out that I also need to give a sample number, so I type loadsig('adc.tr0', 64), but it shows "Number of columns on line 1 of ASCII file C:\HspiceToolbox\adc.tr0
must be the same as previous lines." Can any one help me for this? Thanks.
 

Matlab doesn't understand the .trX format, it has to be converted. Perhaps this thread can help?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top