Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi, I am quite new to Mentor tools. I chose DxDesigner to create the schematic instead of PADs Logic. But it seems the procedure to create a part in DxDesigner's flow. In the Symbol Editor, I called up PADS Decal Brower, chose one decal, and clicked "Apply to Symbol". But it seemed nothing happened to the symbol's properties as shown in the picture below. Should
the "PKG_TYPE" property change to the decal I chose?
Later I found out by typing in the decal name to the "PKG_TYPE", it worked. But this really looks ackward.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.