Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Can anybody give me the design procedures of this lath design?

Status
Not open for further replies.

turtlewang

Member level 2
Member level 2
Joined
Nov 7, 2010
Messages
46
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Activity points
1,605
Hello everyone,

Can anybody provide me the design procedures of the following latch?

Papers or documents about the designing procedures are welcome!

Thanks in advance!
latch.gif
 

hi i'm new and i wanna know the relationship between the diameter and depth of cut in the facing lathe?
and the roughing and finishing cut in the lathe ?
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top