shaikss
Full Member level 4
Hi All,
Attached is the schematic of the circuit and plot of voltage at Inductor Vs Frequency.
I want to plot the Vol across inductor (L1) Vs Freq.
This is the process I have followed:
1. Go to analyses -> Select ac
2. Set the start and stop freq sweep as 0 to 50MHz.
3. Go to Output -> Select calculate. It will take to another window -> Select Vf for ac -> select the net of the inductor L1.
4. Click on Get Expression of the Output. Add the exp to the output window.
5. Click the "Netlist and then Plot" icon.
I expected the output as the resonant circuit output, which has its maximum at 13.56MHz.
But unfortunately, the resultant plot is shown in as attachement.
Can you please the reason for this abnormal behavior?
Correct me if I am wrong at any of the steps.
Thanks,
Shabana
Attached is the schematic of the circuit and plot of voltage at Inductor Vs Frequency.
I want to plot the Vol across inductor (L1) Vs Freq.
This is the process I have followed:
1. Go to analyses -> Select ac
2. Set the start and stop freq sweep as 0 to 50MHz.
3. Go to Output -> Select calculate. It will take to another window -> Select Vf for ac -> select the net of the inductor L1.
4. Click on Get Expression of the Output. Add the exp to the output window.
5. Click the "Netlist and then Plot" icon.
I expected the output as the resonant circuit output, which has its maximum at 13.56MHz.
But unfortunately, the resultant plot is shown in as attachement.
Can you please the reason for this abnormal behavior?
Correct me if I am wrong at any of the steps.
Thanks,
Shabana