thunderboympm
Full Member level 5
- Joined
- Sep 17, 2007
- Messages
- 243
- Helped
- 32
- Reputation
- 64
- Reaction score
- 29
- Trophy points
- 1,308
- Location
- Malappuram, India
- Activity points
- 2,469
Map all symbols to appropriate footprints, add the footprint into the library of Allegro and make sure your DRC is proper and contains no errors in capture. Create a Board outline in Allegro and import the net list..
i got an error like thisProcedure is as below:
1. The "PCB Footprint" attribute of Orcad must have valid footprints, meaning the the Allegro (PCB Editor or Layout- both are same) footprint library has footprints with the same name.
2. Once you create the Orcad netlist, import the same in PCB Editor (FILE -> IMPORT -> LOGIC) and specify the path to Orcad netlist.
3. If your "PCB Footprint" attribute is correct, then your schematics will be properly imported into Allegro.
(---------------------------------------------------------------------)
( )
( Netrev Allegro Import Logic )
( )
( Drawing : robot.brd )
( Software Version : 16.3p004 )
( Date/Time : Thu Dec 29 09:22:24 2011 )
( )
(---------------------------------------------------------------------)
------ Directives ------
RIPUP_ETCH FALSE;
RIPUP_SYMBOLS ALWAYS;
Missing symbol has error FALSE;
SCHEMATIC_DIRECTORY 'D:/my elec backups/Schematics/Orcad/MeA college perinthalmenna/vigeash';
BOARD_DIRECTORY '';
OLD_BOARD_NAME 'D:/my elec backups/Schematics/Orcad/MeA college perinthalmenna/vigeash/robot.brd';
NEW_BOARD_NAME 'D:/my elec backups/Schematics/Orcad/MeA college perinthalmenna/vigeash/robot.brd';
CmdLine: netrev -$ -i D:/my elec backups/Schematics/Orcad/MeA college perinthalmenna/vigeash -y 1 D:/my elec backups/Schematics/Orcad/MeA college perinthalmenna/vigeash/#Taaaaaa01592.tmp
------ Preparing to read pst files ------
#1 ERROR(24) File not found
Packager files not found
#2 ERROR(102) Run stopped because errors were detected
netrev run on Dec 29 9:22:24 2011
COMPILE 'logic'
CHECK_PIN_NAMES OFF
CROSS_REFERENCE OFF
FEEDBACK OFF
INCREMENTAL OFF
INTERFACE_TYPE PHYSICAL
MAX_ERRORS 500
MERGE_MINIMUM 5
NET_NAME_CHARS '#%&()*+-./:=>?@[]^_`|'
NET_NAME_LENGTH 24
OVERSIGHTS ON
REPLACE_CHECK OFF
SINGLE_NODE_NETS ON
SPLIT_MINIMUM 0
SUPPRESS 20
WARNINGS ON
2 errors detected
No oversight detected
No warning detected
cpu time 0:00:45
elapsed time 0:00:00
i got an error like this
how would i rectify? what may be the problem?
how the footprints can be linked to my schematic?
should i do it in capture or during the pcb creation time?
is there any runACO utility as in layoutplus 9.2 ?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?