HI,
I am using CYCLONE-II DSP Development Board for my coll project.. in project i need to use SRAM available on the board... i programmed in VHDL. i maintained all the requirment specified in the data sheet... but i am not able access SRAM... please tell me any thing extra i need to maintain... or how i can proced... thanks in advance..........
It's not said in your post, but Cyclone II DSP Dev Kit is using Synchronous SRAM (SSRAM) rather than simple SRAM. Are you sure, that you understood the timing requirements of the device?
Generally, I suggest to record the waveform at all SSRAM pins with SignalTap II and check against the datasheet.