Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Standardcore voltage for a 180nm process is 1.8V. Usable voltage may range from 0.9 to 2.5V, depending on the foundry's specification. It does not depend on any model type nor EDA tool label.
ok...Thank you very much for your reply.............can you tell me that I am using PTM 180 nm model, is their any difference in designing parameters while designing Analog amplifier as UMC 180 nm process such as Vth, Un, Cox etc
Possibly. But if you can't access the UMC 180nm models, it's still the best what you can do. Or you could try and use the -018 models from a different fab, provided publicly by MOSIS at the bottom of their appropriate MOSIS WAFER ACCEPTANCE TESTS.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
