Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

bandgap reference simulation and layout using cadence

Status
Not open for further replies.

wing0

Junior Member level 1
Joined
Nov 18, 2009
Messages
15
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Location
malaysia
Activity points
1,385
Hi,

How to check the operating point of the start up circuit of the bandgap reference is turn off after the whole circuit is working? (when i ramp my input from 0 to 5V)

And can anyone give me some lab sheet or tutorial or manual on how to design the layout and how to do the layout simulation using cadence?
because my manual is until the schematic simulation only.

Thank you.
 

erikl

Super Moderator
Staff member
Joined
Sep 9, 2008
Messages
8,112
Helped
2,689
Reputation
5,358
Reaction score
2,291
Trophy points
1,393
Location
Germany
Activity points
44,157
wing0 said:
How to check the operating point of the start up circuit of the bandgap reference is turn off after the whole circuit is working? (when i ramp my input from 0 to 5V)
You can use the writefinal option. See .

wing0 said:
... can anyone give me some lab sheet or tutorial or manual on how to design the layout and how to do the layout simulation using cadence?
because my manual is until the schematic simulation only.
Here you can find several tutorials about this stuff.
 

    wing0

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top